Generally, factors affecting the production capacity of impact crusher There are many factors that generally speaking there is a fifth aspect, the following factors will be described me these five areas and propose appropriate solutions
Vertical Roller Mill hardness
1) material: the harder material sand up more difficult and more serious wear and tear on equipment. Sand slow, low capacity. Therefore, we need to pay attention to some of the material on the choice. Composition
2) materials: impact crusher before more material in powder containing the impact of Sand, because these fines easy adherence of delivery. So much for the fines content of the material should advance once sieve
Vertical Roller Mill The screening of possible fines from the material out, so as not to affect the normal operation of the impact Sand. fineness
3) Impact crusher material: fineness requirements, which requires the sand out of the material finer sand is made smaller capacity. Specific requirements in this regard should be, as no special requirements, the general fineness of the material prepared for the fine can be set. Viscosity
4) material: the viscosity of the material, the more likely adhesion. The inner wall of the viscosity of the material in the impact crusher will adhere to the sand chamber, if not promptly clean up, will affect the efficiency of the impact Sand, serious cases may affect the normal operation of the impact Sand . So, the choice of materials, be sure to pay attention to the viscosity of the material is too difficult. Humidity
5) Material: the material contained in the water is large, the material in the impact Sand content easy to adhere to, it tends to result in lower feed conveyor during the blockage, resulting in the ability to reduce the sand. Solve this problem, the first choice when the material necessary to strictly control the humidity of materials, if the humidity is too large selection of materials, can be dried sunshine or other ways to reduce the percentage of moisture in the material.